Custom LED Wall Washer Light shall have good waterproof property, and photoelectric intelligent solar controller with charge discharge protection function, photosensitive automatic control device and time control device, so that the product can effectively save energy, increase effective lighting time and reduce production cost.

During daily use, the charge and discharge controller is drenched and damped, causing short circuit of the circuit board, burning out the control device (triode), and seriously causing corrosion and deterioration of the circuit board, which cannot be repaired. There are two main ways of water inflow: one is to enter the lamp pole through the reserved hole at the top of the lamp pole along the solar cell module and the light source lead; The second is to immerse from the gap of the lamp post door; In addition, the temperature in the warehouse is high, resulting in high humidity in the warehouse, which leads to damage to the controller. Therefore, rainproof measures should be taken to prevent the controller from being damped and damaged.

1. After the area is used, the time difference between startup and shutdown is very small, which can better overcome the disadvantages of traditional LED street lamps due to the large time difference between startup. In this way, LED Wall Washer Light Manufacturers are applicable to areas with rich solar energy resources, areas with rich solar energy resources and areas with available solar energy. In these areas, solar energy can be used not only for the lighting of urban residential areas, high-end residential areas, villas in gardens, public green spaces, urban squares and roads, but also for the household lighting and environmental lighting in remote villages where conventional energy is scarce and it is difficult to generate electricity with conventional energy.